Trane Flash Codes. Trane XE80 No Heat, Blowing Cold Air Intermittent DoItYourself To reset your furnace, locate the power switch or thermostat and turn it off for a few minutes. Notes: Alert flash code will not be implemented for initial release Wait icon will appear on the Comfort Control during: Equipment minimum off time, Charge Assige, Short lock out (see Alert Codes "7 Flash" & "17 Flash")
Trane Rtrm Board Led 2 Flash Code from circuitenginecollie.z13.web.core.windows.net
2 second pause between faults and 4 second pause between sequences 7 flash - W1 / W2 Swapped ReliaTel LED Functions Reliatel Ignition Control (IGN) Green
Trane Rtrm Board Led 2 Flash Code
There is no one-size-fits-all answer to this question, as the codes for a Trane furnace will vary depending on the model and year of your furnace (failure to ignite, no spark, low/ no gas pressure, etc.) 3 Flashes: Pressure switch problem detected Here are some of the most common codes you might encounter with your trane gas furnace: Flashing Slow: This indicates a normal state with no call for heat
Trane XR90, Furnace is running no heat, red light flashing twice. Set. (failure to ignite, no spark, low/ no gas pressure, etc.) 3 Flashes: Pressure switch problem detected 4 highest priority Faults display flash codes sequentially
Trane XR90, Furnace is running no heat, red light flashing twice. Set. There is no one-size-fits-all answer to this question, as the codes for a Trane furnace will vary depending on the model and year of your furnace 2 second pause between faults and 4 second pause between sequences